|
|
 THERMOWELL
The
Thermowell is a stainless steel unit, used in conjunction
with the Exline Stationary Sensor, Exline Stationary Striker
Sensor, or Exline Exhaust Gas Temperature Sensor.
The
Thermowell unit houses the fuse-metal end of the device,
adapting it to be used where the temperature of oil, water,
gas, or other element is to be monitored. Typical applications
are fuel gas headers, oil sumps, water systems, and natural
gas headers.
The Thermowell is designed for use in pressures
not to exceed 3000 psi maximum.
• Total Reliability
• No Maintenance
• No Deterioration
• Reusable
|
| Standard
Sizes in Stock: |
| 1/2" External Pipe Thread |
Length (L) |
1/2" n.p.t. |
3/4" n.p.t. |
1" n.p.t. |
Minimum Applicable
Sensor Length |
1-13/16" |
300704 |
300723 |
--- |
1 1/2" |
3" |
300706 |
300716 |
350192 |
3" |
4" |
300708 |
300724 |
350261 |
4" |
5" |
300710 |
300713 |
350232 |
5" |
6" |
350165 |
350105 |
350464 |
6" |
7" |
300717 |
300729 |
350256 |
7" |
8" |
350363 |
350360 |
350452 |
8" |
9" |
300736 |
300737 |
350419 |
9" |
10" |
350286 |
350481 |
350412 |
10" |
| Special
sizes and material available on request. Allow
for additional delivery time. |
|
|
| How
to Order
|
| Determine
overall length and order by part number.
|
| Typical
Areas Protected by the Thermowell
|
| ·
Fuel Gas Header |
| ·
Water Pipes |
| ·
Oil Pipes |
| ·
Suction and Discharge Gas Headers |
| ·
Heater Treater and Similar Fired Vessels |
|
|
|
|
 Details
of Installation
Use 3/4" or 1/2" coupling*. Weld to header or
piping. Drill hole in header after coupling has been installed.
Care should be used in drilling 1/2" to prevent thread
damage.
When installing Exline Stationary Sensor, Exline Stationary
Striker Sensor, or Exline Exhaust Gas Temperature Sensor
in Thermowell, refer to the “Details of Installation”
section of each individual sensor instruction sheet. Use
no sealants on Stationary Striker Sensor, Exhaust Gas
Temperature Sensor, or Stationary Sensor probe end external
pipe thread.
*Dependent on male pipe thread ordered.
|
